1. Home
  2. Motors
  3. Stepper motor with Gearbox
  4. Rhino DC Motor Driver 50W Compatible with Modbus UART ASCII

Rhino DC Motor Driver 50W Compatible with Modbus UART ASCII

Model: RMCS-2304
Availability : In Stock
₹850.00
Current Reviews: 1 Add Your Review
GST Input Tax Credit @ 18 % of ₹153 available. (Know More)
Warranty : 1 year
Buy 2 or more pieces to get Free Shipping Option
QTY :

Rhino Motion Controls DC Drive RMCS-2304 with UART ASCII is a high performance dc motor drive (10–30 V DC upto 10A) designed for optimized operation of Rhino DC motors.
The salient features of this drive:
  • This drive provides a closed loop speed control for the dc system.
  • The motor programmed speeds are maintained irrespective of the voltages supplied.
  • Also by using this drive, the rated torque of the motor is available at all speeds and the torque does not decrease with change in speeds.
  • It is possible to run the motor in three different modes, analog speed control mode,joystick control mode and digital speed control mode.
  • It has short-circuit protection for the motor outputs, over-voltage and under-voltage protection and will survive accidental motor disconnects while powered-up.
  • This drive is configured using MODBUS ASCII protocol via UART.
  • There is a function in the drive for setting the Modbus Slave Address from 1 to 7 using physical jumpers (Hardware Setting) or using MODBUS Tool Device (Software Setting).
  • There are three user modes in the drive:
    1. Mode0 -  Analog Control Mode
    2. Mode1 - Joy Stick Control Mode
    3. Mode2 -  Digital Speed Control Mode
Note: Heat sink base plate is not included in product. Select checkbox to purchase.
 
General Specifications:
  • Input Supply Voltage: 10 to 30V
  • Peak Current: 5A
  • Smooth and quiet operation at all speeds and extremely low motor heating
  • Dimensions : 67mm x 56mm x 13mm
Analog Control Mode:
  • In this mode motor can be controlled using an external potentiometer through ADC input.
  • In analog mode connect ENA (Pin 4) to GND (Pin 8) to Enable motor.
  • Speed of motor can be changed in analog mode by moving an external potentiometer.
 
 
Joystick Control Mode:
  • In this mode motor can be controlled using a Joystick Module.
  • Direction and Speed of motor can be changed moving the joystick forward and backward.
  • Motor will stop at Zero position of the joystick.
  • In Joystick Mode connect ENA (Pin 4) to GND (Pin 8) to Enable motor.
 
 
Digital Control Mode:
  • In this mode drive can be controlled digitally through ASCII communication using Modbus Poll.
  • Direction/Speed/enable and acceleration of the motor can be change in digital control mode using Modbus poll( similar software can be used)
 
 
Modbus Registers and values for digital communication
 
Package Includes:
  • 1 x RHINO DC MOTOR DRIVER 50W COMPATIBLE WITH MODBUS UART ASCII
     
     
     
Downloads
 

User Manual

Arduino Library


by Banka

PLC Modbus control drive

Customers also purchased