This Programmer is a complete solution for programming any LPC2XXX & P89XXX devices from NXP. Programmer is based on bootloader mode. Can be switched for both devices just by switch press.
- ISP programming through Booloader of LPC2XXX series
- DTR, RTS signals for reset and bootloader enter point
- LPC2XXX / P89XXX selection switch
- Simple 6 wire interface
- Compatible with LPC2138 development board
- Programmer compatible with Flash magic, LPC21ISP & LPC2000 flash utility(NXP)
ISP Supply Jumper Must be open when using 3.3V device.