MDD10A is one of Cytron's motor driver series which offers easy to use features and it can drive two independent motors. MDD10A driver can be used to control the speed, direction, activation and automate all these functions. MDD10A is the dual-channel version of MD10C which is designed to drive 2 brushed DC motors with high current up to 10A continuously.
MDD10A also supports locked-anti phase and sign-magnitude PWM signal. It uses full solid state components that offers faster response time and eliminates the wear and tear of the mechanical relay.
MDD10A can supports motor from 5V to 30VDC. With the presoldered terminals, and on-board manual/test buttons, you can get started even without any microcontroller.it is compatible with Arduino or any microcontroller that can output logic signal at 3.3V or 5.0V, and that includes Arduino Zero and Arduino Micro and Raspberry Pi SBC.
Overview
- Motor Channel: 2
- Operating Voltage (VDC): 5 to 25 (Rev 1.0) 5 to 30 (Rev 2.0)
- Peak Current (A): 30 (10 seconds)
- Continuous Current (A): 10
- Operating Modes: Arduino,PWM
- LEDs Indicator
- Manual Button
Supported Motor
- DC Brush motor (Two Terminals)
- Operating voltage from 5V to 30V
- Rated Current <= 10A
- Peak Current <= 30A
Features
- Bi-directional control for two brushed DC motors.
- Support motor voltage ranges from 5V to 30VDC (Rev2.0).
- No Reverse Polarity Protection at Vmotor, please double check the polarity before power up.
- Maximum current up to 10A continuous and 30A peak (10 seconds) for each channel.
- Support 3.3V and 5V logic level input (for PWM and DIR), compatible with Arduino and Raspberry Pi.
- Solid state components provide faster response time and eliminate the wear and tear of mechanical relay.
- Full NMOS H-Bridge for better efficiency and no heat sink is required.
- Regenerative Braking
- Speed control PWM frequency up to 20KHz (output frequency is same and input frequency).
- Support both Locked-Antiphase and Sign-Magnitude PWM operation. ** Note this is not "RC PWM"
- 2 activation buttons for manual activation or fast test on each channel.
- Dimension: 84.5mm x 62mm
Connections
Check the video
Build a mobile robot with MDD10A and Raspberry Pi:
Part 1
Part 2
Part 3
Part 4
Package Includes:
- 1 x CYTRON DUAL DC MOTOR DRIVER 5V-30V 10AMP - MDD10A (ORIGINAL)
