ARM based high speed controller design.
Alarm output on error.
Can be controlled by PLC, PC Software, Microcontroller, SBC or any other device which can communicate with RTU Modbus.
Its also possible to operate without any controller using Onboard or external potentiometer, PWM, Pulse etc.
In Analog Speed Control mode Current, Speed and Acceleration can be set by using 3 potentiometers available on drive. Current setting range is 4A - 30A.
In Analog Speed Control mode direction can be changed by connecting F/R pin to COM pin of drive.
Over current, over voltage, under voltage protection.
In this drive torque output and speed is stable at high speed.
Up to 15 slaves is available through switch setting, upto 15 motors can be controlled using a single modbus line.
When the power is turned on, the drive can start running motor automatically if enable is connected.
When break applied motor stops motion if it is running but it will not hold torque.
Parameters
Minimum value
Typical value
Maximum
unit
Voltage
20
36
60
V
Current
4
30
A
Logic input current
10
50
mA
Hall power supply
-
5
VDC
Speed control
150
3000
5 00 00
Rpm
Name
Description
DC+/DC-
DC voltage input (DC24V~DC48V)
U, V, W
Motor phase line
Hu, Hv, Hw
Hall signal line
VCC
Hall Power Supply + ( 5VDC )
GND
Hall Power Supply - ( GND )
+5V
External potentiometer power supply
SV
External speed regulation. Dangling when using internal speed control.
COM
Public port (low level)
F/R
Direction, floating or high level is forward rotation, low level reversal
EN
The high level control signal enables the end stop, the low -level operation
BRK
Brake, low level for normal operation, high level shutdown
SPEED
Speed signal output
ALARM
Alarm signal output
The peak output current is set by the P C potentiometer. When the load suddenly becomes large, the output current will be limited to the set value, reducing the motor speed and protecting the motor from damage. The setting range is 4-30A.
The RV knob is a speed-adjusting potentiometer. When the motor is energized, the RV can be rotated to adjust the speed.
SW7=1 SW8=2 SW9=4 SW10=8 is the 485 address selection bit. Follow the 8421 code to set the address bit.
For example: When SW7 and SW9 are ON, the address code of the drive is 5
The factory setting of the EN terminal and the COM terminal is to connect the EN terminal to the COM terminal.
When the power is turned on, the drive can drive the motor to run by itself.
Connect or disconnect the cable between the EN terminal and the COM terminal to control the operation and stop of the motor. When the connection between the EN terminal and the COM terminal, the motor operates. Conversely, the motor stops slowly.
By between COM EN and the access switch or the like controlling the PLC off, required for switching the start and stop the motor.
1 x BRUSHLESS MOTOR DRIVER DC24-48V 750W (BLDC)
PWM Control Connection:
RMCS-6611 BLDC 750W Drive User Manual
RMCS-6611 PC Software Setup
RMCS-6611 Arduino Library
Superb drive with speed and current feedback. Support upto 750W Bldc motor.