This full kit includes a 48V/60V 1500W Electric Hybrid motor and compatible E-bike controller designed to run motors up to 1500 Watts.
This kit you will be able to convert your vehicle into and hybrid vehicle so that your vehicle will run on petrol as well as on battery so whenever you feels that battery is low you can turn on the petrol engine and run on fuel so never get afraid of running out the battery.
This kit has all necessary items to build your brand new scooters to save your efforts in looking out for all compatible products and you can get it in just one go at reasonable cost.
Compatible Scooter Models for retrofitting Honda Navi, Hero Maestro, Honda Dio, Honda Aviater, Honda Cliq, Hero Pleasure, Hero Destini, Hero Duet, Honda Activa and Honda Grazia.
- Rated Operating Voltage: 48V/60V
- Rated Power: 1500W
- Type : BLDC Hub Motor ( Singal Shaft)
- Wheel Size : 10 Inch
- Rated Torque: 30Nm
- Rated Speed: 40-50Km/H
- Max. Working Temperature : 80 C
- Waterproof Grade : IP54
- Weight : 7 – 8 Kg
- Efficiency: 85%
- Rated voltage: DC48V/60V
- Rated power: 1500W
- Rated current: 35A
- Peak Current : 65A
- Efficiency: ≥83%
- Max. Power : 2.1Kw
- Type : BLDC Motor Controller
- Waterproof Grade : IP64
- Regeneration : Yes
- Type : Sine Wave
- On 48V Configuration : Speed ~40-45kmph
- On 60V Configuration : Speed ~45-50kmph
*Note : Speed is depend on the Load Condition, Road Condition, Driving Situation.
Required tools: Multi-meter
- Step1 : Check battery voltage between connection (4) and (5).
If above wires doesn't show any voltage then battery need to be checked.
Step 2 : Connection 12 & 5 should have same voltage as battery voltage.
If connection doesn't show same volatage as battery voltage then problem should be in following module.
1) LED Switch -
a. In LED Off state connection 13 & 5 should show 12V - If 12V not shown then please check key switch connection.
b. In LED On state connection 14 & 5 should show 12V - If 12V not shown LED switch is faulty.
2) Relay - Basic observation to check relay - When LED switch toggles that time relay should create (click sound) if there is no sound then relay is faulty.
a. Connection 17 & 5 should show same as battery voltage - or Red wire in 3 core wire could be damaged.
b. Connection 16 & 5 should show same as battery voltage in LED On stage - or Yellow/Green wire in 3 core wire could be damaged.
Step 3 : Voltage between (8) and (9) should show 5V
Step 4 : Accelerator Setting - in ideal stage Voltage between (8) and (10) should be below 1.2V
- 48V/60V 1500watt motor.
- 48V/60V 1500watt controller.
- Hybrid Throttle.
- Fitting nuts.
- MCB for protection.
- Fitting plate and Support clamp.