Operating voltage: 5V Power supply
UART serial interface
Storage Capacity upto 32G
Adjustable Baud Rate
This product is a data logger that can record data on the memory card through the uart universal serial port. This function is similar to the black box to record the data sent by the host device to the serial port and save the data in text form on the memory card. This product can be used for the flight control board with cleanflight firmware, connected to the corresponding serial port. Through the setting of the cleanflight configurator of the host computer software, the important operation data of the drone can be recorded on the memory card. The flight record playback analysis is performed by the Blackbox flight data recorder software.
Note: After the first memory card is plugged in, the config.txt file will be generated on the memory card, which replaces the baud rate parameter of the serial port. This parameter can be modified. Please use the serial port of the flight control or main circuit. The baud rate is consistent with the baud rate of the recorder.
Input voltage 3.3V~12V (recommended 3.3V~5V)
The memory format is FAT32 and supports up to 64GB of memory.
Adjustable baud rate
The default bootloader is pro mini atmega328P 5V 16mhz
Support storage to fat16/fat32 format tf card, storage capacity can reach 32G
It has a simple command line interface
Change the config file in the tf card on the computer (if it is a new card, the first time you power on the card, the config file will be created automatically), you can change the settings, such as the baud rate. You don't need to buy any special tools to change the serial port settings to use your needs.
Three modes: new, add, command
Baud rate can be set 300-1000000bps
Ensure that the minimum connections to run are vcc, gnd, rx
Two led lights indicate the operating status
Input voltage 3.3V to 12V, preferably 3.3 to 5V.
Standby current 2ma, maximum recording rate 6ma.
1 x Openlog Data Logger FLASH Serial Port Data Storage/Black Box ATMEGA328P