The CC Debugger is a small programmer and debugger for the TI Low Power RF System-on-Chips. It can be used together with IAR Embedded Workbench for 8051 (version 7.51A or later) for debugging and SmartRF Flash Programmer for flash programming. The CC Debugger can also be used for controlling selected devices from SmartRF Studio.
Chips that can be programmed and simulated:
CC2530, CC2531, CC2533
CC2543, CC2544, CC2545
Chips that can be controlled by SmartRF Studio:
CC1120, CC1121, CC1125, CC1175
CC1100, CC1101, CC110L, CC113L, CC115L
Can be used to program PurePath chips:
IAR, SmartRF Studio , SmartRF Flash Programmer , IEEE Address Programmer, PacketSniffer, PurePath Wireless, etc.
Support operating system:
OFF: The debugger has no power or there is no valid firmware on the debugger.
AMBER (BOTH LEDS ON): The debugger is powered, but there is no valid firmware.
RED LED BLINKING: The Debugger is in Boot Recovery Mode.
RED LED ON: No device detected.
GREEN LED ON: The target device has been properly detected. It is possible to start programming/debugging.
1 x CC Debugger
1 x Mini USB cable
1 x 10-pin flat cable