This is a
restricted part primarily used for drone manufacturing and repair. We require
proper end use documentation, identity proof of company/individual as well as
license to manufacture/operate drones or an indemnity bond for the same. Without
this documentation we can not service any order which includes this item.
proper documents are not received within 10 days, refund will be issued from our
side for this item. You can download the format for documents
share this information to any government agency if and when required.
This set is a complete combo of Frame, motors, propellers and ESCs required for a quadcopter.
R450 QUADCOPTOR FRAME WITH INTEGRATED PCB FOR EASY WIRING:
- Built from quality glass fiber and polyamide nylon.
- Integrated PCB connections for direct soldering of your ESCs
- Pre-threaded brass sleeves for all of the frame bolts.
- Colored arms for orientation to keep you flying in the right direction.
- Large mounting tabs on main frame bottom plate for easy camera mounting.
- Easy assembly.
- Width: 450mm
- Height: 55mm
- Weight: 270g (w/out electronics)
- Motor Mount Bolt Holes: 16/19mm
RC BRUSHLESS MOTOR 2212 1000KV WITH PROPELLER ADAPTOR:
- Weight 52 gm
- Runs on 2-3 Cell Li-Po battery
- ESC Requirement minimum 25A
- Length 43.5mm with shaft
- Diameter 28.5mm
- Shaft Diameter 3.17mm
- 980 RPM/V no load speed
- Free Load Current 2.5A
- Maximum Efficiency : 86%
- Thrust with 1047 Prop at 12V: 880gm
- Included : Propeller Adaptor, Motor Mount, Mounting Screws
- 2 Normal props (Puller) + 2 reverse props (Pusher) - total 4 props.
- 10x4.5 inch ABS + Glass fiber plastic.
30A Brushless ESC:
- High rate PWM
- Low resistance
- Sixteen cells Max (with BEC disabled)
- User programmable brake
- Low voltage auto setting based on battery
- Throttle range self-adjusting
- Soft start ramp up
- Auto motor cutoff with reset
- Runs motor in forward or reverse
- Safe power arming program ensures motor will not run accidentally after turn on
- Low torque start
- Auto shut down when signal is lost
- Constant Current: 30A
- BEC 3A
- Input Volt: 6V - 12V
- Max Current: 40A
- Low-Voltage Cutoff: Auto detect and set
- Size: 56mm x 24mm x 8.5mm
- Weight: 26g
Included Product Links:
R450 QUADROTOR FRAME WITH INTEGRAED PCB FOR EASY WIRING
RC BRUSHLESS MOTOR 2212 1000KV WITH PROPELLER ADAPTOR
COUNTER ROTATING PROPELLER 1045/1045R FOR QUADROTOR-MULTIROTOR
BRUSHLESS MOTOR SPEED CONTROLLER ESC 30A
KK2.1 MULTI-ROTOR LCD FLIGHT CONTROL BOARD - PREPROGRAMMED
ARDUCOPTER - APM 2.6 FULL KIT - GPS & POWER MODULE